I decided I would use the table saw to make the outside 3/8-inch rabbets. I still will rout out the inside rabbet for the panel, but I think I can get a clean rabbet with the saw blade without making the huge mess from the router. I will cut the rabbets before I assemble the…
-
-
Doing maintenance around the house is usually DIY. It can be anything from fixing a leaky faucet to cutting the grass. There are always new challenges that I am willing to take on, like fixing a broken wand on our vertical blinds. My grandson, Nagol, was a little too aggressive trying to close the blinds…
-
The next day I took off the 2 cabinet doors to re-finish the frames. I was not going to take apart the doors. I would mask off the hinges and the panels before re-finishing. After looking at the frame of the unfinished door, I decided that half the frame needed to be redone too. I…
-
DIY Project – Upcycling Our Kitchen Cabinet Doors – Phase 2 – Door & Drawer Assembly I had very little problems putting together the doors. As I was getting better at cutting the panel moldings. I only cut one piece of molding too short. Otherwise, I cut the moldings on the miter saw and attached…
-
After finishing the routing of the door frames, I sanded down 40 oak inserts and glued them into the screw holes. I needed for the glue to dry, so I would just sand the front and sides of the frames. I waited until the following day to finish sanding. I went upstairs to the kitchen…
-
DIY Project – Upcycling Our Kitchen Cabinet Doors – Phase 2 – The Router Hoping to have better success with this phase of the kitchen cabinet doors and drawers, I got a head start building the door frames on the next five doors and three drawers. Waiting for the newly formulated stain so I could…
-
Using the knowledge from the installation of the drawer fronts on the main bathroom upstairs, I only routed a 1/4” deep rabbet on the drawer fronts. When I tried to go with a 3/8” deep rabbet, I could not close the drawers completely. The drawers “bottomed out.” Actually, with the additional depth of the new…
-
After installing the first door, I was ready to install the set of two doors. The new hinges were different than the old ones. I was not sure, but they seemed thicker and the hinge bracket was larger. I was worried that the two doors would not fit now with the hinges installed. I placed…
-
I assembled the door frames and panels. That task went fairly well as the miter saw and nail gun cooperated. I would save the installation of the drawer fronts at a later date. I needed to install the hinges. Remember that I routed the edges too deep on the two-door set. So, it was necessary…
-
Since I was off from work over the holidays, I picked up the stain to redo the front of the doors and drawers. I talked with the stain guy and he suggested that I do not use a wipe-on poly. He indicated that the poly would reactivate (re-wet) the stain and I would remove some…